Step1. Download and launch the app. It is a zip file with an exe inside to launch – no installation needed, just make sure the files inside the zip file are extracted into the same directory.
Step2. In the “NFC Reader” section, select the NFC reader and click on Connect. A message box should pop up with a “Successful operation” message.
Step3. Turn off the Molto-1 device if powered on, then long-press the power button (for about 5-7 seconds). This should enable “Programming mode” on the device.
Step4. Place the device on the NFC Reader pad. The serial number of the device should appear in the status section.
Step5. Before burning the seed, you may need to configure the profile settings. The profile settings can be set in the TOTP Profile configuration section. By default, the Profile #0 is set as SHA1, 30 seconds and with the profile name “Token2”. Other 9 profiles are not configured, and if you want to utilize them, you must set the profile settings as shown in the example below:
a) Select the profile number in the “Profile” section
b) Enter “Test” in the Name field and click on “Set Profile Name”
c) Configure the TOTP Settings in the section below the profile name and click on “apply config” button
Once you have configured the TOTP profile settings (time offset, algorithm etc.) you can burn the seed. Make sure the device is in programming mode (If not, turn off the Molto-1 device if powered on, then long-press the power button for about 5-7 seconds - this should enable “Programming mode” on the device).
The NFC Burner app also allows configuring advanced parameters as described below. Kindly note that these settings are global (i.e. not per TOTP profile).
You can change the customer key of your Molto-1 device to make sure nobody else can change the settings of your TOTP profiles. The app should have the correct customer key entered in the system configuration to allow to perform TOTP Profile configuration changes and burning the seeds. To prevent brute-force attacks, the system will perform a factory reset after 200 unsuccessful attempts. Please note that currently, the key is only accepted if set as a hex string.
After changing the key, make sure you also update the configuration by entering the new seed in System Configuration -> Configure Customer Key
The display of the hardware token automatically turns off after a certain period of time. You can change this period in the “Standby time” section. Just choose one of the 4 options and click on “change standby time”.
If for some reason, you want to clean all profiles or in case you forgot the customer key and want to set a new one, you can use the factory reset button. Kindly note that this operation will not only delete all TOTP seeds but also clear the configuration, including the time settings and the default profile settings.
After the reset, you can access the device using the default customer key, which can be set using the "default key" button